PREPARATION AND ELECTROCHEMICAL CHARACTERISTICS OF POLYMER ELECTROLYTE MEMBRANES BASED ON SAN/PVDF-HFP BLENDS

A copolymer of poly(acrylonitrile-co-styrene) (SAN) was synthesized via an emulsion polymerization method. Novel polymer electrolyte membranes cast from the blends of poly(vinylidene fluoride-co-hexafluoropropylene) (PVDF-HFP), SAN and fumed silica (SiO2) are microporous and can be used in polymer lithium-ion batteries. The membrane shows excellent characteristics such as high ionic conductivity and good mechanical strength when the mass ratio between SAN and PVDF-HFP and SiO2 is 3.5/31.5/5. The ionic conductivity of the membrane soaked in a liquid electrolyte of 1 mol/L LiPF6/EC/DMC/DEC is 4.9×10-3 S cm-1 at 25℃. The membrane is electrochemical stable up to 5.5 V versus Li /Li in the liquid electrolyte. The influences of SiO2 content on the porosity and mechanical strength of the membranes were studied. Polymer lithium-ion batteries based on the membranes were assembled and their performances were also studied.     

Influence of SMA content on the electro-optical properties of polymer-dispersed liquid crystal prepared by monodisperse poly(MMA-co-SMA)/LC microcapsules

Monodisperse poly(methyl methacrylate) (PMMA) particles containing various concentrations of stearyl methacrylate (SMA) were prepared, and a liquid crystal (LC) was swollen into the particles using a solute co-diffusion method (SCM). Phase separation behaviors between the polymer and LC were monitored by utilizing an optical and a polarized microscope (OM/POM). The monodisperse LC microcapsules were then applied to a polymer-dispersed liquid crystal (PDLC), and the electro-optical properties were investigated. As a result, the threshold and driving voltages were improved when the SMA content increased. The long alkyl chains of SMA in the capsules should exist at the interface of the LC and polymer resulting in an enhancement of phase separation between the polymer and LC, which largely influences the electro-optical properties of PDLC.     

Effects of type and number of impellers and liquid viscosity on the power characteristics of mechanically agitated gas—liquid systems

Effect of the type and number of high-speed impellers installed on a common shaft on the power characteristics was investigated in water and glucose solutions of different concentration. Different configurations of the Rushton or Smith turbines, pitched blade turbines, propeller, and A 315 impeller were tested. Measurements of power consumption were carried out within the transitional and turbulent regime of the fluid flow using the strain gauge method. Baffled agitated vessels with inner diameter of 0.288 m and 0.634 m were used for the experiments. Liquid height in the vessels was equal to the vessel diameter or it was twice higher. The relative power consumption was compared for different configurations of the impellers. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

Flammability studies of 3-methyl pyridine/water system

In industrial processes, information on the safety property of chemicals is essentially crucial for safe handling during unit operations. Ensuring the safe use of combustible or flammable substances in processes is unlikely without detailed investigations of their flammability characteristics and related hazards. We studied 3-methyl pyridine (3-picoline), e.g., flammability limits (LFL/UFL), maximum explosion pressure (P _max), maximum explosion pressure rise (dP/dt)_max, minimum oxygen concentration (MOC), vapor deflagration index (K _g), and characterized the influence of inert steam (H₂O) on critical parameters for 3-picoline/water mixtures at 270°C, 1 atm, various oxygen concentrations, and vapor mixing ratios (100/0, 30/70, 10/90 and 5/95 vol.%) with a 20-L-Apparatus in simulated conditions, respectively. The results showed that the flammability characteristics of 3-picoline_(aq) all increased with the oxygen concentration. However, as the composition of inert steam increased, the flammability parameters and the degree of fire and explosion hazards were significantly reduced, instead. This study elucidated the flammability properties of 3-picoline mixed with inert steam. The conclusions could be applied to proactively prevent the relevant processes from incurring fire and explosion accidents.     

煤加氢液化残渣的流变特性研究

采用从煤直接液化实验装置取得的液化残渣，研究了它的流变性及温度和油、沥青质、固体含量对其流变性的影响。液化残渣是剪切变稀的非牛顿型假塑性流体，非牛顿指数随温度升高而不断减小，温度越高越接近牛顿流体行为。液化残渣对温度非常敏感，在升温过程中其表观黏度下降很快，且没有出现黏度峰。在液化残渣中加入少量的循环油后其表观黏度大幅下降；而在加入少量沥青质后则表现出低温下黏度变大，高温下黏度变小的现象；固体含量则始终是黏度增大的因素，表明其黏度与油、沥青质和固体含量关系密切。液化残渣的黏度－温度关系符合Arrhenius关系式，但在升温过程中出现了拐点，低温段的黏流活化能比高温段的要大。     

Structures and electrochemical characteristics of several kinds of alloys

The structures and the electrochemical characteristics of La_0.7−x Ce_xMg_0.3Ni_2.8Co_0.5 (x = 0.1–0.5) alloy, Ti_0.25−x Zr_xV_0.35Cr_0.1Ni_0.3 (x = 0.05–0.15) alloy and AB_3<x<5-type alloy, which are the representative examples of AB₃-type alloy, solid solution alloy and non-AB₅-type alloy, respectively, have been investigated, and the performances of MH-Ni battery in which AB_3<x<5 type alloy is used as the negative electrode material are examined at relatively low temperature.     

Capillary gas chromatography of pesticide residues in foods: Application of a split/splitless inlet system

Residue mixtures of pesticides in foods which were difficult to separate by packed-column gas chromatography were determined by capillary gas chromatography and electron capture detection. Manual injections of sample and reference standard were made with a 10 μL syringe on a septum-enclosed, split/ splitless inlet system. Optimal peak height repeatability (± 3%( was achieved with three-μL injections which were made within time periods of four hours or less. The average linearity coefficient (slope( obtained for detector response as a function of solution concentration was 1.1.     

超临界流体萃取仪器的研制

本文报道了以国产原配件为基础，成功地研制了分析规模的超临界流体萃取仪器、并对仪器性能进行了全面考察，仪器性能稳定，重现性良好（ＲＳＤ＜３．１％），定量线性关系可靠，可满足定量萃取的要求。     

Characteristics and production of thermostable α-amylase

Thermostable α-amylases have application in a variety of industrial processes and enzymes from a substantial number of thermophilic bacteria and fungi have been screened and characterized to varying degrees. The characteristics of these enzymes are summarized in this review. The genetics of α-amylase production inBacillus subtilis is reviewed and classical and recombinant DNA approaches to increasing α-amylase production are discussed.     

壳聚糖／聚丙烯酸聚电解质复合物膜对水／有机液体系的渗透汽化性能

以壳聚糖和聚丙烯酸为原料制备了聚电解质复合物膜，并对其分离水／乙醇体系的渗透汽化特性和浓度，温度，化学组成等因素的影响进行了研究，发现后处理方法对复合物膜的分离性能影响很大。同时对其它水／有机液体系，该膜也具备优异的分离性能。